TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
‹› Only pull carefully on the A/C unit (heater) so that bracket - A - does not break.
‹› To loosen bolt - B -, reach between A/C unit (heater) floor mat on right wheel housing (to make this possible, Fresh Air Blower (V2) has been
removed earlier).
-
Remove the screws - B - and remove the bracket - A - from the A/C unit (heater). The bracket remains attached to the wiring harness inside the
vehicle.
-
Loosen the vehicle wiring harness mounts (for example, the cable ties) on the right side of the A/C unit (heater).
-
Disengage both flanges for coolant pipes to heater core - A - and for expansion valve (to evaporator) - B - from pass-through of grommet - C -.
‹› When removing the A/C unit (heater), make sure the two coolant pipes of the heater core do not get caught and bent or damaged on plenum
chamber or noise insulation mat.
‹› Observe wiring harness, individual electrical wiring connections may get damaged when pulling on harness.
-
Remove A/C unit (heater) - A - towards passenger side.