TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
‹› The groove - A - and pin - B - must align.
-
With drive chain in this position, first route it on the intake camshaft chain sprocket at the top - arrow -.
-
Rotate intake camshaft clockwise - arrow A - slowly with the toothed belt tensioner (T10020) until the camshaft adjuster fits on the camshaft.
‹› If pin does not fit into notch: Remove chain and place the chain on again.
-
Tighten camshaft adjuster bolt with the socket ( T40080).
Installation is in reverse order of removal, note the following: