TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
Evaporative Emission Control Canister: Service and Repair
EVAP Canister
Removing
‹› Checking for leaks. Refer to => [ Leak Detection Test, Performing ] See: Leak Detection Pump/Testing and Inspection/Leak Detection Test,
Performing.
-
Remove rear part of exhaust system. See: Engine, Cooling and Exhaust/Exhaust System
-
Remove the rear muffler heat shield. See: Engine, Cooling and Exhaust/Exhaust System
-
Disconnect vent lines and connecting lines - 3 -, - 4 - and - 5 - by pressing the release button.
-
Remove bolts - 1 -, - 2 - and - 6 -.
-
Release the retaining tabs in direction of - arrow - with a screwdriver and remove the EVAP canister.
Installing
‹› Tightening specifications. Refer to => [ EVAP Canister and Leak Detection System Assembly Overview ] See: Service and Repair.
Installation is in reverse order of removal, note the following:
-
Press on vent and connecting lines until they engage audibly.
-
Install the rear muffler heat shield. See: Engine, Cooling and Exhaust/Exhaust System
-
Install exhaust system. See: Engine, Cooling and Exhaust/Exhaust System