TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
Only remove new steering pinion from packaging when it has been assembled.
Prevent contact with electrical components!
-
Observe general repair notes. Refer to => [ General Repair Information ] See: Service and Repair/Procedures for this.
-
Insert steering pinion into steering gear housing.
-
Rotate steering pinion until spiral spring with sensor wire - arrow - can be locked. While doing this, the marking applied during removal must
align with steering gear housing.
‹› Sensor wire must be replaced. It is supplied in replacement part kit.
-
Pull anti-twist element off the spiral spring.
-
Tighten steering pinion with a new hex nut - arrow -.