TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
Stabilizer Bar: Service and Repair
Stabilizer Bar
Stabilizer Bar
Special tools, testers and auxiliary items required
‹› Locating Pins (T10096)
‹› Engine/Transmission Jack (V.A.G 1383 A)
‹› Torque Wrench (V.A.G 1331)
‹› Torque Wrench (V.A.G 1332)
Removing
-
Remove subframe. Refer to => [ Subframe ] See: Subframe/Front Subframe/Service and Repair/Subframe
-
Remove stabilizer bar from subframe - 11 and 14 -.
-
Remove stabilizer.
Installing
Installation is in reverse order of removal, with special attention to the following:
Tightening specifications, refer to => [ Subframe, Stabilizer Bar, Transverse Link, Ball Joint, Level Control System Sensor Assembly Overview ] See:
Subframe/Front Subframe/Service and Repair/Subframe, Stabilizer Bar, Transverse Link, Ball Joint, Level Control System Sensor Assembly
Overview
Tightening specifications, refer to => [ Electro-Mechanical Steering Gear Assembly Overview ] See: Steering/Steering Gear/Service and
Repair/Electro-Mechanical Steering Gear Assembly Overview
-
Install subframe. Refer to => [ Subframe ] See: Subframe/Front Subframe/Service and Repair/Subframe
-
Replace locking element after each removal item - 11 - => [ Locking Element ] See: Subframe/Front Subframe/Service and Repair/Subframe,