TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
-
Insert (3424) into slot of wheel bearing housing.
-
Using a ratchet and the (3424), open the wheel bearing housing slot.
-
Pull wheel bearing housing with ball joint down from shock absorber tube and remove.
Installing
Installation is in reverse order of removal, with special attention to the following:
Tightening specifications, refer to => [ Wheel Bearing Housing and Wheel Bearing Unit, Assembly Overview ] See: Rear Knuckle/Service and Repair
Tightening specifications, refer to => [ Subframe, Stabilizer Bar, Transverse Link, Ball Joint, Level Control System Sensor Assembly Overview ] See:
Subframe/Front Subframe/Service and Repair/Subframe, Stabilizer Bar, Transverse Link, Ball Joint, Level Control System Sensor Assembly
Overview
-
Replace locking element after each removal item - 11 - => [ Locking Element ] See: Subframe/Front Subframe/Service and Repair/Subframe,
Stabilizer Bar, Transverse Link, Ball Joint, Level Control System Sensor Assembly Overview.
-
Align nuts - arrows - according to markings made earlier and tighten.