TTS Quattro Roadster Wheel Bearing Housing Removal & Replacement
-
Always set the wheel bearing down on the wheel hub - 2 -.
Installing
Installation is in reverse order of removal, with special attention to the following:
Tightening specifications, refer to => [ Wheel Bearing Housing and Wheel Bearing Unit, Assembly Overview ] See: Rear Knuckle/Service and Repair
Tightening specifications, refer to => [ Subframe, Stabilizer Bar, Transverse Link, Ball Joint, Level Control System Sensor Assembly Overview ] See:
Subframe/Front Subframe/Service and Repair/Subframe, Stabilizer Bar, Transverse Link, Ball Joint, Level Control System Sensor Assembly
Overview
-
Replace locking element after each removal item - 11 - => [ Locking Element ] See: Subframe/Front Subframe/Service and Repair/Subframe,
Stabilizer Bar, Transverse Link, Ball Joint, Level Control System Sensor Assembly Overview
-
Align nuts - arrows - according to markings made earlier and tighten.
-
Tighten drive axle to wheel hub threaded connection.