TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
‹› The raised tab - b - on the locking ring is offset to tab - a -.
CAUTION!
The selector mechanism could be damaged.
Do not touch selector lever handle locking button - 1 - when removing the handle.
The handle or the shift mechanism pull rod will be damaged.
-
Remove the selector lever handle and boot upward - arrow - without touching the locking button - 1 -.
Installing
Install in reverse order, noting the following:
-
Turn locking ring all the way in direction of - arrow -.
‹› The raised tab - b - on the locking ring is offset to tab - a -.
‹› The locking button points in the driver's direction.
CAUTION!
The selector mechanism could get damaged.
The locking button - 1 - must be projecting out when installing. If the button should be pushed in while the handle is removed, it must be brought
back into the installation position. Refer to => [ Selector Lever Handle Locking Button, Bringing into Installation Position ] See: Procedures.
If the locking button is pushed in while the handle is being installed, it will destroy the handle and the selector mechanism pull rod - 3 -.
-
Press handle onto the lever completely without touching the locking button - 1 -.
‹› When doing this, handle must engage into ring groove of the selector lever.
-
Turn locking ring all the way in direction of - arrow -.