TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
‹› Replace
6
Selector Lever Cable
‹› Do not bend or kink
‹› Do not lubricate cable eye
‹› If selector lever cable boots are damaged, replace
‹› Removing and Installing, refer to => [ Selector Lever Cable ] See: Shift Linkage/Shift Cable/Service and Repair
‹› Adjusting, refer to => [ Selector Lever Cable, Adjusting ] See: Shift Linkage/Shift Cable/Adjustments
7
Nut
‹› 8 Nm
‹› Quantity: 4
‹› Shift mechanism to body
8
Stop Buffer for Selector Lever
‹› Clipped into selector mechanism
9
Selector Mechanism Function Unit
‹› With integrated selector mechanism circuit board (Selector Lever (E313))
CAUTION!
Risk of destroying electronic selector mechanism components with static discharge.
‹› Do not touch circuit board with fingers.
‹› With integrated Tiptronic switch and shift lock solenoid
‹› Check Tiptronic switch or shift lock solenoid in "Guided Fault Finding".
‹› If the Tiptronic switch or the shift lock solenoid are faulty, replace the shift mechanism function unit.
‹› Emergency release, refer to => [ Selector Mechanism Emergency Release ] See: Selector Mechanism Emergency Release
‹› Removing and Installing, refer to => [ Tiptronic Switch ] See: Sensors and Switches - A/T/Transmission Position Switch/Sensor/Service and
Repair
10
Locking Spring
11
Bolt
‹› 3.5 Nm
12
Pivot Pin
13
Bolt
‹› 3.5 Nm
‹› Quantity: 4
14
Locking Plate
15
Selector Mechanism Shift Unit
‹› With glued seal