TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
‹› All driveshaft bolts are tightened.
-
Align the intermediate bearing in its elongated holes so the driveshaft or bearing is not under stress.
-
Tighten combi-bolt - 1 -. The combi-bolts - 1 - must lie inside the four heat shield centering tabs - 2 -. Tightening specification
-
Reconnect exhaust system and ensure it is not under stress.
-
Install the floor panel crossmember - arrows -, if equipped.
‹› If droning noises are audible while driving, do the following:
‹› Remove balance nut and balance washer - arrows -.