V8 Quattro V8-3562cc 3.6L DOHC (PT) (1990)
Selector Switch
-
Insert adjusting pin through adjusting bores on multi-function switch.
Note:
The adjusting pin is provided with every new multi-function switch. Otherwise, a 4 mm dia. drill bit may be used. The adjusting pin is fitted
tightly, the drill bit is not so tightly fitted. If necessary, align both adjusting holes by turning the multi-function switch in the elongated holes
and insert pin or drill bit.
-
Align adjusting holes and insert pins in holes.
-
Torque multi-function switch retaining bolts to 7 ft. lbs.
-
Remove adjusting pin from multi-function switch then press ball head forward to Park position.
Selector Linkage
-
Position selector lever in Park, then check to ensure socket and ball head are aligned.
-
Attach selector lever cable to ball head.
-
If head and socket are not aligned, adjust selector lever cable as follows:
Selector Linkage
-
Loosen bolt 1 on cable support bracket until support bracket can be moved without exerting too much force.