V8 Quattro V8-3562cc 3.6L DOHC (PT) (1990)
/Page-1625002.png)
clean remaining adhesive of screw thread of wheel bearing housing with screw-tap M 14 x 1.5
10. Pivot mount
when installed, cross points must point up
11. Bonded rubber bushing
12. Plain washer
WARNING: Do not remove or install axle bolt washer with vehicle on a hoist. Lower vehicle to the ground betore removing installing.
CAUTION:
Do not move vehicle without driveshaft or outer constant velocity joint installed or wheel bearing will be damaged.
When disassembling suspension strut install tool 20701 before removing (or use VW 340).
Do not heat up wheel bearing housing or wheel bearing will be damaged. Always replace selt-locking nuts and bolts.
