1 Series E81 116i (N43) 3-door
Installation:
Fit support sleeve (4) with crankshaft seal (1) on crankshaft.
Align groove (2) centrally to housing partition (3).
Coat both grooves (2) on crankshaft seal (1) with Loctite primer,
manufacturer's number 171000, and expose to air for approx.
one minute.
Push crankshaft seal (1) by hand as far as possible onto running
surface.
Carefully remove support sleeve (4).
Bolt special tool 11 9 182 with special tool 11 9 184 to
crankshaft.
Draw in crankshaft seal with special tool 11 9 181 in
conjunction with special tool 11 9 183 until flush.
Before filling with sealing compound:
Insert brush with Loctite primer, manufacturer's number 128357,
as far as possible into grooves (1) on radial seal and coat
housing partition on engine block.
RA Replacing crankshaft seal (N43B16)
BMW AG - TIS
15.01.2013 12:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
