1 Series E81 116i (N43) 3-door
33 32 091
Replacing a guide arm
Note:
If the guide arm is detached from the rear axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
Remove rear wheel
•
Remove both stabilizer links from stabilizer and turn stabilizer
in upward direction
Release screw.
Installation:
If necessary, raise wheel carrier in area of brake caliper by hand.
Replace screw.
Tightening torque 33 32 4AZ
.
Important!
Make sure during installation that in the connection area to the
wheel carrier the tapered end of the bearing bushing (of the
rubber mount) points in the direction of the wheel carrier.
RA Replacing a guide arm
BMW AG - TIS
15.01.2013 16:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -