1 Series E81 116i (N43) 3-door
52 13 030
Removing and installing/replacing backrest
frame on left or right front seat
Necessary preliminary tasks:
•
Remove front seat
•
Remove rear panel on front seat backrest
Detach cable connectors.
Release airbag wiring harness (2) from cable holders on seat
mechanism.
Raise release clip (3) and pull plug (4) out of plug housing (1).
Note:
If necessary, release yellow plug housing (1) from holder on seat
mechanism.
Unfasten plug connection (1) and disconnect.
Detach cable connectors.
Release wiring harness (3) from cable holders on seat
mechanism.
Unfasten plug connection (2) and disconnect.
Important!
Feed all wiring harnesses carefully through the seat and
backrest mechanism as the edges of the frame can be sharp.
E92 only:
Lever out retaining clip (1) on left and right.
Installation:
Replace retaining clip (1).
Make sure retaining clip (1) is correctly seated.
RA Removing and installing/replacing backrest frame on left or right front seat
BMW AG - TIS
15.01.2013 20:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -