1 Series E81 118i (N46T) 3-door
Before fitting special tool 11 9 291 , it is essential to turn special
tool 11 9 293 back.
Remove special tools 11 9 291 and 11 9 292 .
Rotate eccentric shaft (1) at hexagon so that toothing (2) points
to inlet side as shown in illustration.
Note:
Cylinder head bolts on inlet side are only accessible in this
position.
Release screws (1) between engine block and cylinder head.
Open plug (1).
RA Removing and installing/sealing cylinder head (N46T)
BMW AG - TIS
18.01.2013 20:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
