1 Series E81 118i (N46T) 3-door
Installation:
Clean sealing surface (1) and degrease thoroughly in area of
housing partition.
Apply a light coat of oil to running surface (2) of radial seal.
Note:
Support sleeve (4) is supplied with radial seal (1).
When radial seal (1) is installed, only support sleeve (4) may be
used as a slip sleeve.
Radial seal (1) has a groove (2) on both left and right sides.
Important!
After installation, grooves (2) must be filled with sealing
compound.
Important!
The seal between the engine block and radial seal is
described below.
The engine block will not be leakproof at the outside of the
radial seal if you fail to comply with the individual work steps
and the work sequence.
Note:
The required parts are available from the BMW Parts Service
(ETK).
Remove screw caps (1) from injector (2).
Screw on needle and insert plunger.
Injector (2) contains the sealing compound Loctite,
manufacturer's number 128357.
Bottle (3) contains the primer Loctite, manufacturer's
number 171000.
RA Replacing crankshaft radial seal (N46T)
BMW AG - TIS
18.01.2013 20:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
