1 Series E81 118i (N46T) 3-door
Replace sealing ring on plug (1).
Insert plug (1) and tighten down.
Tightening torque: 11 31 6AZ
.
Check hub (2), replace if necessary.
Install hub (2).
Note:
Picture shows a three-hole hub.
Installation:
Replace central bolt (1).
Insert central bolt (1) and install without play.
Important!
Do not tighten down central bolt (1) yet.
Note:
Picture shows a three-hole hub.
While central bolt is slackened, balancing shafts can be rotated by
hand at ends.
Align balancing shafts in such a way that special tool 11 5 140
can be pushed from inlet side underneath balancing shafts.
RA Replacing timing chain (N46T)
BMW AG - TIS
18.01.2013 20:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -