1 Series E81 118i (N46T) 3-door
Note:
Magnet wheel (1) is secured with a lug groove in eccentric
shaft (2).
Important!
Install original antimagnetic screw (3) only.
Insert screw (3) and tighten down.
Tightening torque 11 37 5AZ
.
Insert screws and tighten down eccentric shaft sensor (1).
Tightening torque 11 37 2AZ
.
Clamp special tool 11 9 320 as illustrated in a vice.
Deposit bearing bracket (1) with eccentric shaft downwards in
special tool 11 9 320 .
Install inlet camshaft.
Assemble engine.
RA Removing and installing/replacing eccentric shaft (N46T)
BMW AG - TIS
18.01.2013 20:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
