1 Series E81 118i (N46T) 3-door
Unlock lug (1) in direction of arrow, slide plug (2) out of DME
plug (3).
Unlock plug (1) and remove.
Withdraw profile seal from electronics box.
Installation:
To ensure leak-tightness, make sure profile seal is correctly
seated in electronics box.
Work step
Note:
Unlock plug on air-mass flow sensor and disconnect.
Unlock plug on throttle valve and disconnect
Unlock plug on DISA and disconnect
Unlock plug on differential pressure sensor and disconnect.
Unlock plug on blow-by heating fitting and disconnect
Unlock plug on A/C compressor and disconnect
Unlock plug on alternator and disconnect.
Unlock plug on tank venting valve and disconnect.
Unlock plug of crankshaft pulse generator and disconnect.
Unlock plug on oil pressure switch and disconnect.
Unlock plug on coolant temperature sensor and disconnect
Unlock plug on knock sensors and disconnect
Release control lines on starter motor.
Unlock plug on oil level sensor and disconnect
Remove engine underbody
protection
RA Replacing wiring harness section for engine (N46)
BMW AG - TIS
18.01.2013 20:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -