1 Series E81 118i (N46T) 3-door
31 12 080
Removing and installing/replacing both
tension struts
Necessary preliminary tasks:
•
Except M3: Remove both front wheels
•
Remove front underbody protection
Release nut (1); if necessary, grip at Torx socket (T40).
Installation:
Keep tension strut to swivel bearing connection clean and free
from oil and grease.
Replace self-locking nut.
Tightening torque 31 12 2AZ
.
Release bolt (1) and remove tension strut.
Raise locking nut (2) in area of bore and detach from front axle
carrier.
Installation:
Replace locking nut.
Tighten bolt connection in normal position.
Tightening torque 31 12 1AZ
.
RA Removing and installing/replacing both tension struts
BMW AG - TIS
18.01.2013 21:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -