1 Series E81 118i (N46T) 3-door
Warning!
Risk of injury!
Secure spring strut against falling out.
Centering pin missing: remove tension strut (on spring strut dome)
and mark position of threaded pins to wheel arch.
Release nuts (1) and remove spring strut with swivel bearing
towards bottom.
Installation:
Clean contact surface in spring strut dome.
Align spring strut using centering pin to bore in wheel arch or
studs to wheel arch and push upwards.
Replace self-locking nuts.
Tightening torque 31 31 1AZ
.
Important!
Replace faulty sealing washer (1).
Reinstall sealing washer (1) and plate insert (2).
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
RA Removing and installing complete left or right spring strut shock absorber
BMW AG - TIS
18.01.2013 21:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
