bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

3 RA Removing And Installing _ Replacing Lower Section Of Steering Spindle > < 1 RA Removing And Installing_replacing Upper Section Of Steering Column Trim|Page 1005
Page 1
background image

32 31 020

Removing and installing / replacing lower
section of steering column trim 

Necessary preliminary tasks:

Remove upper section of steering column trim

Move steering column into "top" and "extended" position and

do not secure with adjusting lever

Press detent lugs outwards a litttle and unclip steering column trim
downwards.

Installation:

Align steering column trim by means of detent lugs to steering
column and press up as far as it will go.

Press steering column trim on both sides together a little and then
press upwards completely until detent lugs snap into place.

Check installation position, correct if necessary.

RA  Removing and installing / replacing lower section of steering column trim

BMW AG - TIS

18.01.2013  22:01

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

3 RA Removing And Installing _ Replacing Lower Section Of Steering Spindle > < 1 RA Removing And Installing_replacing Upper Section Of Steering Column Trim|Page 1005