1 Series E81 118i (N46T) 3-door
If necessary, remove exhaust system bracket from rear axle
carrier.
If necessary, remove rear muffler from body.
Release nut (1) and remove eccentric washer (2).
Pull out eccentric screw and remove camber arm (3).
Installation:
Note insertion direction of eccentric screw.
Align eccentric screw by means of marking to camber arm.
Fit eccentric washer (2).
Replace nut (1).
Tightening torque 33 32 9AZ
.
Replacement:
Replace lower spring pad (refer to Removing and
installing/replacing coil spring).
Version with xenon lights:
Release screw (1) and remove bracket (2).
Tightening torque 37 14 4AZ
.
After installation:
•
Perform chassis alignment check
RA Removing and installing/replacing left or right camber arm
BMW AG - TIS
18.01.2013 22:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
