1 Series E81 118i (N46T) 3-door
Check dust sleeve (1) for damage and replace if necessary.
Clean contact face (2) of brake piston and apply a thin coating of
anti-squeak compound.
Important!
Dust sleeve must not come into contact with anti-squeak
compound as this may cause the dust sleeve to swell.
Clean contact face (1) of brake caliper and apply a thin coating
of anti-squeak compound.
Clean hammerhead guides and apply a thin coating of anti-squeak
compound.
Important!
Brake pad with indentation (1) is intended for
accommodating the brake pad wear sensor and must be fitted
on the piston side.
Replacement:
Remove lining retaining springs (1).
Installation:
Clean contact face of brake carrier and apply a thin coating of
anti-squeak compound.
RA Removing and installing or replacing brake pads on both front disc brakes (TRW f
BMW AG - TIS
18.01.2013 22:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
