1 Series E81 118i (N46T) 3-door
51 14 110
Removing and installing/replacing rear model
designation
Important!
The Instructions for number/letter combination cementing
serve as the basis for these repair instructions and must be
followed without fail.
Fitting dimensions (E81/E87):
Mark reference point (1).
Dimension "A" to rear lid radius runout (3) and dimension "B" to rear lid outer edge.
Stick on adhesive tape (2) horizontally at reference point (1).
Position model designation at reference point (1) and stick on.
Observe dimension "D".
Dimensions:
A= 52 mm
B= 45 mm
RA Removing and installing/replacing rear model designation
BMW AG - TIS
18.01.2013 23:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
