1 Series E81 120i (N46T) 3-door
25 11 111
Replacing shift rod joint
Necessary preliminary tasks:
-
Remove rear underbody protection
-
Remove front middle and rear middle heat shields.
-
Release propeller shaft from transmission.
-
Release propeller shaft centre mount and tie propeller shaft
to one side
Tasks are described in Removing propeller shaft
-
Remove transmission cross-member and lower transmission
Detach locking clip.
Pull shift rod (1) out of shift rod joint (2).
Installation:
Grease shift rod pin (3).
Grease,
refer to BMW Service Operating Fluids.
Lever spring washer (1) out of groove and push a little towards
rear.
Press dowel pin (2) upwards/downwards out of shift rod joint and
remove shift rod joint.
Installation:
Grease ball of selector shaft.
Grease, refer to BMW Service Operating Fluids.
Replace spring washer (1).
RA Replacing shift rod joint
BMW AG - TIS
20.01.2013 20:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -