1 Series E81 120i (N46T) 3-door
41 21 930
Replacing inside left side frame (B-pillar
reinforcement)
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 21 930).
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
Spot-weld bonding is used on this vehicle. Observe specific
procedure.
Use only approved spot-welding apparatus for repairs!
Removal of side panel described in 41 35 101 .
Place vehicle on straightening bench.
Following new body parts are required (refer to Electronic Parts
Catalogue ETK):
-
(1) Side panel, rear (including reinforcement, B-pillar)
-
(2) Shaped part, B-pillar, inner (not shown)
-
(3) Shaped part, B-pillar, rear (not shown)
Installation:
Side panel and B-pillar reinforcement are fitted as a composite
unit.
Mark severance cut (1) in accordance with measurement and cut.
Measurement a = approx. 80 mm from side panel severance cut.
Important!
Cut outer metal sheet only.
Open weld joints in area (1).
RA Replacing inside left side frame (B-pillar reinforcement)
BMW AG - TIS
20.01.2013 22:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -