1 Series E81 130i (N52K) 3-door
86 10 ...
Positioning of multitrailer hood for
maintenance and repair work
Important!
At least two persons are needed to install and remove the
hood from the platform.
Before installing and removing the hood, secure the BMW
multitrailer and the entire combination against rolling. For this
purpose, use the parking brake and the chocks of the BMW
multitrailer.
The hood can also be set up and lowered with the aid of the
universal lift available from BMW in conjunction with the roof
racks and the hood adapter. Under no circumstances should
work of any kind be carried out below the suspended hood.
For maintenance and repair work, raise the hood using a lifting
platform. Twin-column lifting platforms, body lifting platforms and
twin-stamp underfloor platforms are suitable. The seating plates
and areas of the lifting platform must be adjustable according to
the dimensions of Fig. R86 0196.
The lifting platform must conform to the relevant legal provisions
of the accident prevention regulations and be serviced as
specified. Comply with the lifting platform operating instructions, in
particular the safety instructions and the carrying capacity.
Make sure you adhere to the BMW-recommended work area of 5
x 7 m and to an escape route of 0.6 m between two lifting
platforms.
Please comply with the following instructions before raising the
hood:
-
Raise only when it is unloaded;
-
Ensure sufficient clearance between the seating
plates/seating areas and the GFP edge of the hood;
-
The hood must always be positioned in the middle of the
lifting platform.
RA Positioning of multitrailer hood for maintenance and repair work
BMW AG - TIS
22.01.2013 03:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
