1 Series E81 130i (N52K) 3-door
12 14 521
Replacing crankshaft pulse generator (N52,
N52K, N51, N53)
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Important!
Aluminium-magnesium materials.
No steel screws/bolts may be used due to the threat of
electrochemical corrosion.
A magnesium crankcase requires aluminium screws/bolts
exclusively.
Aluminium screws/bolts must be replaced each time they are
released.
The end faces of aluminium screws/bolts are painted blue for
the purposes of reliable identification.
Jointing torque and angle of rotation must be observed
without fail (risk of damage).
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
Note:
Installation location of pulse generator for crankshaft is
underneath starter motor.
Preparatory tasks:
•
Remove intake air manifold
RA Replacing crankshaft pulse generator (N52, N52K, N51, N53)
BMW AG - TIS
22.01.2013 03:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -