1 Series E81 130i (N52K) 3-door
Important!
Fit screw cap without using a tool and tighten hand-tight.
Then tighten screw cap with special tool 16 1 020 until
notch (1) points to marking (2).
Note:
Illustration shows the tank removed.
Carefully raise service cap (1).
Unlock and detach vent line (2).
Installation:
Clean sealing faces and install new seal (3).
Make sure that the lever sensor moves freely before fitting the
service cap.
Locating rods (4) must fit correctly in the hole of the delivery unit.
Installation:
Service cap can only be installed in one position.
When installing, make sure lug (1) of service cap engages in
corresponding opening (2) on fuel tank.
Unclip black return lines (1) from bracket.
Unlock and disconnect quick-release fastener (2) of fuel line.
Important!
Do not use any tools to release the fuel feed line.
Draw off remaining fuel from surge chamber.
Carefully lift fuel pump with fuel level sensor (3) out of fuel tank. If
necessary, turn fuel pump 90
°
counterclockwise and tilt towards
lever sensor.
RA Removing and installing or replacing fuel gauge sensor (petrol/gasoline, right)
BMW AG - TIS
22.01.2013 03:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
