1 Series E81 130i (N52K) 3-door
Important!
Always replace clutch plates fouled e.g. by oil, cleaning agent.
Check clutch plate for damage and friction rust in hub profile and
replace if necessary.
Check clutch disk for wear:
Measure lining protrusion at lining rivets at closing head (A) in
each case.
Note:
Rivet connection
a)
Closing head
b)
Swage head
Replace clutch plate if lining protrusion at closing head (A) is less
than 1 mm.
Push clutch disk onto the cleaned transmission input shaft and
check for easy movability.
Important!
Do not clean SAC clutch with high-pressure cleaner or
washing machine as this may impair function of adjustment
unit.
Clean friction surface only.
Check SAC clutch for wear and damage and replace if
necessary.
Reinstalling removed SAC clutch and clutch plate:
Installation:
N52
Screws must be replaced.
Jointing torque and angle of rotation must be observed without
fail.
RA Removing and installing or replacing clutch (SAC 228)
BMW AG - TIS
22.01.2013 04:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
