1 Series E81 130i (N52K) 3-door
Remove release module (1) from spring wire clip.
Remove release module.
Note:
Illustration similar.
Installation:
Check spring wire clip (5) and ball pin (6) for damage and replace
if necessary.
Note:
Illustration similar.
Clutch release bearing with moving thrust plate (1).
Swivel motion of thrust plate (1) possible.
Note:
Illustration similar.
Installation:
Do not grease guide sleeve.
If guide sleeve is greased, the release lever can stick on the guide
sleeve.
Clean guide sleeve (7).
Note:
Illustration similar.
RA Removing and installing or replacing clutch release bearing/lever
BMW AG - TIS
22.01.2013 04:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
