1 Series E81 130i (N52K) 3-door
Previous version
Detach release bearing (1).
Installation:
Clean all sliding surfaces on clutch release bearing, check for
damage and replace if necessary.
Do not grease clutch release bearing.
Sliding surfaces (2) of clutch release bearing must rest on
sliding surfaces (3) of release lever.
Apply a thin coating of grease to sliding surfaces (2) of
release bearing.
Grease, refer to BMW Service Operating Fluids.
Note:
Illustration similar
Caution!
New clutch release bearing fitted!
See following graphic.
Important!
On E60/E61/E63/E64/M5 and M6 - apply a light coating of
grease to guide sleeve.
New clutch release bearing:
Clutch release bearing with moving thrust plate (1).
Swivel motion of thrust plate (1) possible.
RA Removing and installing or replacing clutch release bearing/lever
BMW AG - TIS
22.01.2013 04:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
