1 Series E81 130i (N52K) 3-door
21 52 510
Removing and installing/replacing clutch
slave cylinder (plastic)
Special tools required:
•
13 3 010
Note:
After completing work bleed clutch hydraulic system.
Seal hydraulic line to clutch slave cylinder with special tool
13 3 010 .
Release nuts and remove clutch slave cylinder (1) with
holder (2).
Installation:
Replace self-locking nuts.
Tightening torque 21 52 5AZ
.
Important!
N47 with H-transmission only
Clutch slave cylinder must not rest at the side on the
transmission.
Failure to comply with this instruction may result in leaks at
the clutch slave cylinder.
RA Removing and installing/replacing clutch slave cylinder (plastic)
BMW AG - TIS
22.01.2013 04:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
