1 Series E81 130i (N52K) 3-door
Release aluminium screw on right next to cable retaining plate
with special tool 00 9 010 .
Installation:
Aluminium screws must be replaced.
Tightening torque 23 00 2AZ
.
Disconnect connector (1).
Release screws.
Unscrew holder (2).
Tightening torque 23 00 1AZ
.
Supporting transmission:
Support transmission with special tools 23 4 050 , 23 0 132
and 00 2 030 .
Secure transmission with tensioning strap (1).
Tasks are described in Transmission bracket.
After completion of work, check transmission oil level.
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
When removing and installing the transmission, support the front
end of the engine at the housing with an installation aid
(e.g. transmission lifter).
RA Removing and installing transmission (GS6-37BZ) N51/N52/N52K/N53
BMW AG - TIS
22.01.2013 04:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -