1 Series E81 130i (N52K) 3-door
24 13 014
Replacing output flange shaft seal (GA6L45R)
Special tools required:
•
23 0 020
•
23 1 210
•
24 4 360
•
24 4 370
Important!
After completion of work, check transmission fluid level.
Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious
damage to the automatic transmission!
Necessary preliminary tasks:
•
Remove underbody protection
•
Remove heat shields
•
Remove complete exhaust system
•
Remove front muffler (N45T/N46T)
•
Remove transmission cross-member
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
To rotate propeller shaft, unlock parking gear.
RA Replacing output flange shaft seal (GA6L45R)
BMW AG - TIS
22.01.2013 04:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
