1 Series E81 130i (N52K) 3-door
25 11 000
Removing and installing shift lever
Special tools required:
•
25 1 120
Necessary preliminary tasks:
•
Remove reinforcement carrier.
•
Remove rear underbody protection.
•
Remove heat shields.
•
Remove knob for shift lever.
•
Remove gaiter for shift lever cover.
If necessary
Support transmission with workshop jack.
Remove screws and nuts.
Remove cross-member.
Tightening torque 23 71 1AZ/2AZ
.
Remove shift rod (2).
Installation:
Grease shift rod pin.
Key:
1.
Retainer
2.
Shift rod
RA Removing and installing shift lever
BMW AG - TIS
22.01.2013 04:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
