1 Series E81 130i (N52K) 3-door
31 10 000
Removing and installing complete front axle
(with spring struts)
Warning!
Danger to life!
Mount securing fixture for vehicle on lifting platform to prevent
the vehicle from slipping off or tilting down.
Secure engine in installation position to prevent it from falling
down.
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Mount securing fixture for vehicle on lifting platform
•
Secure engine in installation position
•
Disconnect battery negative lead
•
Remove both brake calipers from swivel bearing and tie up
•
Remove front assembly underside protection
•
If necessary, remove radiator seal
•
If necessary, remove steering gear cover on left and right
RA Removing and installing complete front axle (with spring struts)
BMW AG - TIS
22.01.2013 04:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
