1 Series E81 130i (N52K) 3-door
31 12 000
Removing and installing/replacing left or right
control arm
Note:
If the control arm is detached from the front axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
Except M3:
•
Remove front wheel
•
Remove front underbody protection
Except M3:
If necessary, remove jointed rod of ride-height sensor from control
arm.
M3 only:
Slacken nut (1).
Remove jointed rod (2) from control arm.
Installation:
Sensor lever (3) must point from ride-height sensor to left front
wheel.
Tightening torque 37 14 3AZ
.
RA Removing and installing/replacing left or right control arm
BMW AG - TIS
22.01.2013 04:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -