1 Series E81 130i (N52K) 3-door
31 21 090
Removing and installing/replacing left or right
swivel bearing
Special tools required:
•
31 2 230
Necessary preliminary tasks:
•
Remove front brake disk
•
Remove front pulse generator from swivel bearing
If necessary, remove jointed rod of ride-height sensor from control
arm.
Slacken control arm bolt connection on front axle carrier in order
to prevent control arm rubber mount from being overelongated.
Remove control arm from swivel bearing.
Remove tie rod end from swivel bearing.
Warning!
Risk of injury!
Tension strut is under tension.
Remove tension strut from swivel bearing
RA Removing and installing/replacing left or right swivel bearing
BMW AG - TIS
22.01.2013 04:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
