1 Series E81 130i (N52K) 3-door
31 35 000
Removing and installing/replacing front
stabilizer
Important!
To avoid complaints being made by the customer about noise
(e.g. grating), set the car on its wheels and tighten down the
stabilizer mounting to specified torque.
Necessary preliminary tasks:
•
Remove front underbody protection
•
E88: Remove V-strut on left and right
•
Remove stabilizer link on both sides from stabilizer
M3:
Remove reinforcement plate.
Release nut (1) for return line (2).
Installation:
Replace self-locking nut.
Tightening torque 32 41 11AZ
.
Except M3: Release screws (1) and remove brackets.
Release nuts (2); if necessary, grip screws after repair.
Remove stabilizer (3); if necessary, press off front axle carrier
with a suitable tool.
Installation:
Check both rubber mounts for damage, replace if necessary.
Replace self-locking nuts (do not tighten down).
Set car on its wheels and tighten down nuts to tightening torque
31 35 1AZ
.
RA Removing and installing/replacing front stabilizer
BMW AG - TIS
22.01.2013 04:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
