1 Series E81 130i (N52K) 3-door
32 00 150
KDS chassis/wheel alignment check with load
up to design position
Important!
Carry out chassis/wheel alignment check in design position
only:
-
if the technical prerequisites for an alignment check with
ride-height input are lacking
-
if, in spite of repairs having been carried out, the car's
ride height between the left and right sides is still outside
the tolerance
-
if the vehicles in question have been involved in an
accident
-
if the models are M models
Note:
•
Read and comply with General information and definitions.
•
Read and comply with General chassis definition.
•
If necessary, prepare lifting platform.
•
Drive vehicle onto lifting platform.
Note: The front and rear wheels must be positioned centrally
on the rotary and sliding plates.
•
Remove locking pins from both rotary and sliding plates, align
pickup using bubble level and activate
RA KDS chassis/wheel alignment check with load up to design position
BMW AG - TIS
22.01.2013 05:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
