1 Series E81 130i (N52K) 3-door
32 21 151
Replacing left or right tie rod
Note:
If the tie rod end to tie rod screw/bolt connection is released, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
Remove front wheel
Important!
Do not release tie rod end from swivel bearing with impact
tool.
Rubber gaiter of tie rod end must not be damaged!
Release nut (1); if necessary, grip at Torx socket.
Remove tie rod end (2) from swivel bearing.
Installation:
Keep tie rod end to swivel bearing connection clean and free from
oil and grease.
Replace self-locking nut.
Tightening torque 32 21 3AZ
.
RA Replacing left or right tie rod
BMW AG - TIS
22.01.2013 05:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
