1 Series E81 130i (N52K) 3-door
Release screw (1).
Tightening torque 32 41 1AZ
.
Note:
If necessary, raise and/or turn fluid reservoir in order to gain better
access to hose clamps.
Unfasten hose clips.
Disconnect suction line and radiator return line from fluid reservoir.
Lift out fluid reservoir.
Installation:
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
RA Removing and installing / replacing fluid reservoir for power steering with acti
BMW AG - TIS
22.01.2013 05:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
