1 Series E81 130i (N52K) 3-door
Bleeding rear-axle brake circuit
Connect bleeder hose with collecting tray to bleeder valve on rear
right brake caliper.
Close bleeder valve.
Run bleeding routine with DIS with bleeder valve open.
After completing routine, press brake pedal 5 times to floor; clear
and bubble-free brake fluid must flow out.
Close bleed valve.
Repeat procedure at rear left.
Bleeding front-axle brake circuit
Connect bleeder hose with collecting tray to bleeder valve on front
right brake caliper.
Close bleeder valve.
Run bleeding routine with DIS with bleeder valve open.
After completing routine, press brake pedal 5 times to floor, clear
and bubble-free brake fluid must flow out.
Close bleed valve.
Repeat procedure at front left.
Switch off brake fluid changer and remove from expansion tank.
Check brake fluid level.
Close expansion tank.
Note:
Pay attention to rubber seal (1) in sealing cap.
RA Bleeding brake system with DSC
BMW AG - TIS
22.01.2013 05:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
