1 Series E81 130i (N52K) 3-door
Lift out retaining spring (1).
Remove plastic plugs (1).
Unfasten guide screws (1) and lift out brake caliper towards rear
of vehicle.
Installation:
Tightening torque 34 11 4AZ
.
Clean guide screws only; do not grease.
Check threads.
Replace all guide screws which are not in perfect condition.
Important!
Tie brake caliper back and do not allow to hang from brake
hose.
Remove outer brake pad.
Inner brake pad is located with its spring in the piston.
Important!
Mark any worn brake pads.
In the event of one-sided brake pad wear, do not change
brake pads round.
Observe minimum thickness of brake pads.
Clean brake pads.
Do not grease backs of brake pads sleeve.
RA Removing and installing or replacing brake pads on both front disc brakes (Teves
BMW AG - TIS
22.01.2013 05:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
