1 Series E81 130i (N52K) 3-door
Release bolts (1) and detach brake anchor plate.
Installation:
Tightening torque 34 21 2AZ
.
Important!
To release brake disc: Do not under any circumstances strike
friction ring with a hammer or similar!
If necessary, carefully tap on base of brake disc chamber with
a rubber mallet.
Clean contact surface of brake disc at wheel hub thoroughly
and remove traces of corrosion.
Unevenness on contact surface may result in distortion of
brake disc!
Release screw (1) and remove brake disc (2).
Installation:
Replace screw.
Tightening torque 34 21 1AZ
.
After installation:
•
Adjust handbrake
•
Read and comply with notes on braking in new brake discs /
brake pads.
RA Removing and installing/replacing both brake disks
BMW AG - TIS
22.01.2013 05:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
