1 Series E81 130i (N52K) 3-door
35 31 000
Removing and installing or replacing clutch
pedal
Necessary preliminary tasks:
•
Remove pedal trim.
Disconnect return spring (1).
Press end of pin (2) together with offset pliers and press out pin.
Detach locking clip (3) and pull clutch pedal off bearing block.
Installation:
Replace locking clip (3).
Locking clip (3) must be seated with both legs in the pin groove.
Installation:
Check bearing bushings (1) and replace if necessary.
Lightly grease bearing bushings (1).
RA Removing and installing or replacing clutch pedal
BMW AG - TIS
22.01.2013 06:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
