1 Series E81 130i (N52K) 3-door
Use suitable wheel centring element supplied with corresponding
balancing machine.
1.
Basic flange
2.
Wheel centring element
3.
Type flange
4.
Clamping nut
Also refer to section on Workshop Equipment.
Use special tool 36 1 030 for testing.
Special tool 36 1 030 consists of:
(1)
Stand 36 1 031
(2)
Post with clamp 36 1 032
(3)
Holder with clamp 36 1 033
(4)
Clamp 36 1 034
(5)
Measuring roller 36 1 035
(6)
Dial gauge 36 1 036
Position special tool 36 1 030 on tire tread.
Turn wheel by hand and measure max. radial tire runout.
Note:
Measuring device must be vertical to tire tread.
Position special tool 36 1 030 on tire side wall.
Turn wheel by hand and measure max. lateral tire runout.
Note:
Measuring device must be vertical to tire side wall.
Never measure on printed text on tire!
If necessary, check disk wheel (rim) for radial and face runout.
RA Checking one road wheel on balancing machine for face and radial runout (wheel r
BMW AG - TIS
22.01.2013 06:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
